Pocket Bike Mods | Pocket Bike Racing Information
RSS icon Home icon

This is a list of mods you can do to your pocket bike if you’re on a budget, or you are new to the sport and looking to give your pocket bike that first extra kick.

Probably the most effective per dollar upgrade you can get is a timing key. For about $20, a timing key can increase your pocket bikes engines timing by 10 degrees. Be aware that this will increase performance on some engines, but can also decrease performance in others depending on what the factory set timing is.

Replace your stock metal reed with a high performance Fiberglass one. Fiberglass reeds allow more and faster fuel into the carb, this resulting in a faster burning of fuel, which increases low, mid and top end power. A fiberglass reed will cost about $20-$30.

If your bike came with a black air cleaner instead of an air filter, its loosing potential power, by adding a high performance air filter and vstack, your allowing more and faster air into your engine, which will increase performance and engine life. Typically $30-$40.

One of the most important things that should be considered when buying modifications is your fuel filter. A Hi Flow Fuel Filter will run you about $7 to $15 and protects your engine from harm by dirt, plastic, and other debris. It is a must for every bike. Check your fuel line if it comes with a fuel filter, if not get one, otherwise dirt and other foreign objects will get inside your fuel and block your carb.

A good set of HP clutch springs will make your acceleration a lot better over stock and coming out of corners etc, you will have a lot more power for only $15 to $25. All CAGS come with 3 shoe clutches, the major let down with these clutches are the springs.

If you have general engine knowledge or instructions, these mods make for a very good starting point to modifying your pocket bike. When installing these mods, the flywheel, clutch, and carb must be removed first. If you have any doubts about whether you know what you’re doing, you could visit a pocket bike repair shop and they would gladly do the install for a small fare.

Leave a reply